Introduction

This plugin allows to update firmware on SteelSeries gamepads:

• Stratus Duo
• Stratus Duo USB wireless adapter
• Stratus+
• Aerox 3 Wireless
• Rival 3 Wireless

SteelSeries Rival 100 gaming mice support is limited by getting the correct version number. These mice have updatable firmware but so far no updates are available from the vendor.

This plugin supports the following protocol IDs:

• com.steelseries.fizz
• com.steelseries.gamepad
• com.steelseries.sonic

GUID Generation

These devices use the standard USB DeviceInstanceId values, e.g.

• USB\VID_1038&PID_1702

Quirk Use

This plugin uses the following plugin-specific quirks:

Flags:is-receiver

The device is a USB receiver.

Since 1.8.1

Update Behavior

Gamepad

Gamepad and/or its wireless adapter must be connected to host via USB cable to apply an update. The device is switched to bootloader mode to flash updates, and is reset automatically to new firmware after flashing.

Mice

The device is not upgradable and thus requires no vendor ID set.

Wireless Mice

Rival 3 Wireless

The mouse switch button underneath must be set to 2.4G, and its 2.4G USB Wireless adapter must be connected to host.

Aerox 3 Wireless

The mouse switch button underneath must be set to 2.4G, and its 2.4G USB Wireless adapter must be connected to host; or the mouse must be connected to host via the USB-A to USB-C cable.

Vendor ID Security

The vendor ID is set from the USB vendor, in this instance set to USB:0x1038

External Interface Access

This plugin requires read/write access to /dev/bus/usb.

Version Considerations

This plugin has been available in fwupd >= 0.8.0 but only learned how to update devices in 1.8.1.